SoundPEATS H3 Wireless Bluetooth Earbuds with Hybrid Triple Drivers, Adaptive ANC, LDAC and aptX Lossless

Description

SoundPEATS H3 wireless Bluetooth earbuds feature 55dB adaptive active noise cancellation with a bandwidth of up to 4000Hz and up to 99.8% ambient-noise reduction. Six microphones support real-time ANC and CVC call processing. The app provides Indoor, Outdoor, Transport and Adaptive ANC modes. Each earbud uses one 12mm biological-diaphragm dynamic driver and two balanced armature drivers. The earbuds support LDAC and aptX Lossless wireless audio codecs with a bitrate of up to 1.2Mbps. They are Hi-Res Audio Wireless certified and Qualcomm Snapdragon Sound certified. iOS devices do not support LDAC. Each earbud has three microphones for AI ENC, including beamforming microphones and an inner microphone. Wind-noise reduction and CVC 8.0 support clearer voice transmission during calls. The earbuds also include a voice-optimized transparency mode with Voice Enhance and Standard Transparency options. Playback lasts up to 7 hours on a single charge with ANC off, approximately 4 hours with ANC on, and approximately 37 hours in total with the charging case. A 10-minute charge provides approximately 2 hours of playback. Battery-life testing used the AAC codec, 60% volume and ANC off; actual results may vary. Bluetooth 5.4 and a 60ms low-latency gaming mode support wireless connectivity and synchronized audio. The earbuds have an IPX5 rating and nano-coating. Wear detection includes a seal check through the app. The SOUNDPEATS app supports dual-device connection, EQ adjustment, earbud location tracking, tone-volume control and case battery-level display, with nine EQ presets. Dual-device connection cannot be used at the same time as LDAC. To pair, remove the earbuds from the charging case, remove the insulating film, then select SOUNDPEATS H3 in the phone's Bluetooth settings. To reset, keep the earbuds in the open charging case and hold the case button for 10 seconds until the indicator flashes red and white alternately twice. To enter manual pairing mode, hold the case button for 3 seconds until the indicator flashes white quickly.